Fwd: [Lugro-mesh] Mas pruebas, menos resultados.

[Sebastián D. Criado]

On Fri, August 31, 2007 6:45 pm, Sebastian Dominguez wrote:
> de http://www.wing-project.org/directions:device_driver_agnostic
>
> Encapsulation
>
> The Roofnet's routing protocol operates below the IP protocol using
> its own frame format. A virtual interface named \textbf{srcr1} using
> multi-hopping is created at each node. Since this interface advertises
> a classical MTU size of 1500 bytes, the physical wireless device's MTU
> size has been set to 1900 bytes, leaving 400 bytes for the routing
> protocol's header. However some wireless adapters' device drivers do
> not support MTU's sizes higher than 1500 bytes. We decided then to
> lower the \texttt{srcr1}'s advertised MTU size to 1100 bytes leaving
> the physical wireless device's MTU size to 1500 bytes.
>
> Nuestro wifi0 esta en MTU 1500 (la ath2 esta en 1900)
>

Si mal no recuerdo el seteo a 1900 es paa los becons nada mas.

Se lo pregunte a Gus en una reunión por que me parecía lo mesmo, pero el
tema es los rate y no el mtu.

Saludos.,-

-- 
Sebastián D. Criado - scriado{en}ciudad.com.ar
NO A LA MATRICULACIÓN OBLIGATORIA -
http://noalamatricula.wordpress.com/about/
L.U.G.Ro - http://www.lugro.org.ar
GNU/Linux Registered User # 146768
- -------------------------------------------------------------------
"Si el Universo fuera un programa estaría hecho en C, y correría sobre
un sistema UNIX"
                                                  Anónimo.